Table 148: Determining The Service Interim Accounting Interval; Table 149: Sample Acct-Start Message For A Service Session - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Copyright © 2010, Juniper Networks, Inc.
NOTE: You can also configure interim accounting for users. A user interim accounting
interval is configured in the Acct-Interim-Interval RADIUS attribute (RADIUS attribute
85). You use the aaa user accounting interval command to specify the default user
interim accounting interval, which is used when RADIUS attribute 85 is not configured.
See "Configuring Remote Access" on page 3 for information about configuring user
interim accounting.
When the Service-Interim-Acct-Interval attribute is configured for a service, Service
Manager uses the guidelines shown in Table 148 on page 655 to determine the correct
interim accounting interval to use for the service.

Table 148: Determining the Service Interim Accounting Interval

Service-Interim-Acct-
Interval Value
0
1–599
600–86400
86401 or greater
The tag for the service-interim-acct-
interval attribute does not match the
tag for any service-activate attribute
(VSA 26-65)
Table 149 on page 655 describes a sample Acct-Start message for a service session. In
the table, the three fields used by Service Manager are shown in bold characters. An
Acct-Start message for a subscriber session without any active services does not include
the Service-Session attribute.

Table 149: Sample Acct-Start Message for a Service Session

RADIUS Attribute
acct-status-type
username
event-timestamp
acct-delay-time
nas-identifier
acct-session-id
Chapter 27: Configuring Service Manager
Service Manager Action
Disables interim accounting for the service
Uses 600
Uses the specified value
Uses 86400
Discards the service-interim-acct-interval attribute
Sample Value
1
client1@isp1.com
1112191723
0
ERX-01-00-06
erx FastEthernet 12/0:0001048580:002478
655