Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 110

JunosE 11.2.x Broadband Access Configuration Guide
radius route-download server
72
Specify a particular VRF whose downloaded routes you want synchronized. If you
do not specify an optional VRF, the current virtual router is used.
Specify the IP address and IP mask that identifies the subset of downloaded routes
that you want cleared in the routing table of the current virtual router or in the
specified VRF.
Use the wildcard character (*) to clear all downloaded routes in the routing table
of the current virtual router or in the specified VRF.
Use the following keywords to perform global clearing operations:
all—Clears all downloaded routes from all virtual routers and VRFs.
reload—Initiates a download of routes and then clear the routes from the routing
table of all virtual routers and VRFs.
NOTE: Clear commands fail if the route-download server is in the process of
downloading routes from the RADIUS server.
Example 1—Clear all downloaded routes from the current virtual router
host1#clear ip routes download *
Example 2—Clear a subset of routes from a specific VRF
host1#clear ip routes download vrf NY12 192.168.50.102 255.255.0.0
Example 3—Clear all downloaded routes from all virtual routers and VRFs
host1#clear ip routes download all
There is no no version.
See clear ip routes download
Use to configure a RADIUS route-download server and enter RADIUS Configuration
mode. Specify the IP address of the RADIUS server that you want to download access
routes.
NOTE: When the RADIUS route-download server is enabled, the router ignores the
radius rollover-on-reject enable command—the radius rollover-on-reject enable
command has no effect for a RADIUS route-download server.
You can configure a single instance of the route downloader on the router.
Example
host1(config)#radius route-download server 10.10.5.10
host1(config-radius)#
Copyright © 2010, Juniper Networks, Inc.