Configuring Dhcp Features; Creating An Ip Interface; Single Clients Per Atm Subinterface; Figure 3: Single Ppp Clients Per Atm Subinterface - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual
Software for e series broadband services routers broadband access configuration guide
Table of Contents
Advertisement
JunosE 11.2.x Broadband Access Configuration Guide
Configuring DHCP Features
Creating an IP Interface
Single Clients per ATM Subinterface
58
Example
host1(config)#aaa domain-map sunnyvale.com
host1(config-domain-map)#ipv6-prefix-pool-name local_addr_pool
Use the no version to remove the IPv6 local address pool name from the domain map.
See ipv6-prefix-pool-name.
DHCP provides a mechanism through which computers using Transmission Control
Protocol/IP (TCP/IP) can obtain an IP address and protocol configuration parameters
automatically from a DHCP server on the network.
The E Series router provides support for the following DHCP features:
DHCP proxy client
DHCP relay agent
DHCP relay proxy
DHCP local server
DHCP external server
For more information about DHCP, see "DHCP Overview Information" on page 449.
You can configure IP interfaces that support the following configurations:
A single PPP client per ATM or Frame Relay subinterface
Multiple PPP clients per ATM subinterface
Figure 3 on page 58 shows a conceptual view of the configuration of a single PPP client
per ATM subinterface.
Figure 3: Single PPP Clients per ATM Subinterface
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
