Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 132

JunosE 11.2.x Broadband Access Configuration Guide
94
Queues
Schedulers
Traffic classes
The JunosE-IP-PIB file is updated with each JunosE release. Since the PIB is implemented
by both Juniper Networks SRC and JunosE devices, distribution of the PIB file to customers
is not necessary. Customers can access the proprietary PIB file, on approval from Juniper
Networks, through Juniper support.
You can configure SRC clients on a per-virtual-router basis. To configure the SRC client:
Enable the SRC client. With the CLI sscc enable command you can specify
1.
BER-encoded information exchange for COPS-PR.
host1(config)#sscc enable cops-pr
Specify the IP addresses of up to three service activation engines (SAEs) (primary,
2.
secondary, and tertiary). You can optionally specify the port on which the SAEs listen
for activity.
host1(config)#sscc primary address
host1(config)#sscc secondary address 192.168.12.1 port 3288
(Optional) Enable policy and QoS configuration support for IPv6 interfaces.
3.
host1(config)#sscc protocol ipv6
(Optional) Enable policy and QoS configuration support for L2TP interfaces on an
4.
L2TP access concentrator (LAC).
host1(config)#sscc protocol lac
(Optional) Specify on which router the TCP/COPS connection is to be established.
5.
host1(config)#sscc transportRouter chicago
(Optional) Specify a fixed source address for the TCP/COPS connection created for
6.
an SRC client session.
host1(config)#sscc sourceAddress 10.9.123.8
(Optional) Specify a fixed source interface for the TCP/COPS connection.
7.
host1(config)#sscc sourceInterface atm 3/0
(Optional) Specify the delay period during which the SRC client waits for a response
8.
from the SAE.
host1(config)#sscc retryTimer 120
(Optional) Enable the user IP address mask to be sent to a Policy Decision Point
9.
(PDP) in place of the interface IP address mask for a virtual router.
host1(config)#sscc option user-ip-mask-override
(Optional) Enable the calling station ID to be sent to a PDP for a virtual router.
10.
host1(config)#sscc option send-calling-station-id
Copyright © 2010, Juniper Networks, Inc.