Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 288

JunosE 11.2.x Broadband Access Configuration Guide
Table 49: RADIUS IETF Attributes Supported by JunosE Software
(continued)
Attribute
Number Attribute Name
[4] NAS-IP-Address
[5] NAS-Port
[6] Service-Type
[7] Framed-Protocol
[8] Framed-IP-Address
[9] Framed-IP-Netmask
[11] Filter-Id
[12] Framed-MTU
[13] Framed-Compression
[18] Reply-Message
[22] Framed-Route
[24] State
250
Description
IP address of the network access server (NAS) that is requesting authentication
of the user
You can use the radius update-source-addr command to override this behavior;
see "Configuring Remote Access" on page 3.
Physical port number of the NAS that is authenticating the user
See the radius nas-port-format, radius pppoe nas-port-format unique, and
radius vlan nas-port-format stacked commands in "Configuring RADIUS
Attributes" on page 163.
Type of service the user has requested or the type of service to be provided
Admin, Login, NAS Prompt, or Framed only
Framing protocol used for framed access
Standard value of 1 set for PPP
Nonstandard value of 1008 set for dynamic ATM
IP address to be configured for the user
0.0.0.0 or absence is interpreted as 255.255.255.254
See the radius include framed-ip-add acct-start command in "Configuring
RADIUS Attributes" on page 163.
IP network to be configured for the user when the user is a router to a network
Absence implies 255.255.255.255
Name of the filter list for the user
Interpreted as input policy name
The maximum transmission unit to be configured for the user, when it is not
negotiated by some other means (such as PPP).
When sent in an Access-Request with an EAP-Message, indicates the maximum
size of the EAP-Message string that the external server supports.
Always set to none.
Text that may be displayed to the user
Only the first instance of this attribute is used
String that provides routing information to be configured for the user on the NAS;
in the format:
<addr>[/<maskLen>] [<nexthop> [<cost>]] [tag <tagValue>] [distance
<distValue>]
An arbitrary value that the router includes in new Access-Request packets from
the previous Accept-Challenge
Applicable for CLI, telnet, or EAP message exchange
Copyright © 2010, Juniper Networks, Inc.