radius include dhcp-option-82
ANCP-Related Juniper Networks VSAs
Copyright © 2010, Juniper Networks, Inc.
Use to include the following supported IPv6 accounting attributes in Acct-Stop
messages:
IPv6-Acct-Input-Octets [26-151]
IPv6-Acct-Output-Octets [26-152]
IPv6-Acct-Input-Packets [26-153]
IPv6-Acct-Output-Packets [26-154]
IPv6-Acct-Input-Gigawords [26-155]
IPv6-Acct-Output-Gigawords [26-156]
If you enable inclusion of the IPv6 accounting-related VSAs in Acct-Stop messages,
the router also includes the VSAs in Interim-Acct messages.
You can control inclusion of the IPv6 accounting attributes by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include ipv6-accounting acct-stop enable
Use the no version to restore the default, disable.
[26-159] DHCP-Option 82
Use the following command to manage the DHCP Option 82 RADIUS attribute.
radius include dhcp-option-82
Use to include the DHCP Option 82 attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
You can configure RADIUS to include the dhcp-option-82 attribute
See radius include
Example
host1(config)#radius include dhcp-option-82
Use the no version to restore the default, disable.
You use the radius include command to specify information about Access Node Control
Protocol (ANCP), also known as Layer 2 Control (L2C), that you want to include in the
RADIUS Access-Request, Acct-Start, and Acct-Stop messages. Also, if you specify
Acct-Stop messages, the router includes ANCP information in Interim-Acct messages
that the router sends to RADIUS. By default, the router does not include the ANCP-related
information provided by the Juniper Networks VSAs in RADIUS messages.
Chapter 3: Configuring RADIUS Attributes
225