Setting A Baseline For Dhcp Local Server Statistics; Monitoring Addresses Excluded From Dhcp Local Server Use; Table 103: Show Ip Dhcp-Local Excluded Output Fields - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Setting a Baseline for DHCP Local Server Statistics

Monitoring Addresses Excluded from DHCP Local Server Use

Purpose
Action
Meaning
Copyright © 2010, Juniper Networks, Inc.
There is no no version.
To set a baseline for DHCP local server statistics:
Issue the baseline ip dhcp-local command:
host1#baseline ip dhcp-local
There is no no version.
To set a baseline for DHCP local server statistics for a specific ATM, Fast Ethernet, or
Gigabit Ethernet interface:
Issue the baseline ip dhcp-local command with the optional interface keyword to
specify the type of interface and interface specifier:
host1#baseline ip dhcp-local interface atm 3/1
To set a baseline for DHCPv6 local server statistics:
Issue the baseline ipv6 dhcpv6-local command:
host1#baseline ipv6 dhcpv6-local
Display addresses that have been excluded by the ip dhcp-local excluded-address
command. The DHCP local server does not allocate excluded addresses, because they
are already used by devices on the subnetwork.
To display excluded IP addresses:
host1(config)#show ip dhcp-local excluded
Dhcp Excluded Addresses
-----------------------
Low
Pool Address
-------- --------- ----------
default 10.10.1.1
default 10.10.1.5 10.10.1.30
cable2 10.10.2.1
home.com 10.10.3.1
cable4 10.10.4.1
cable5 10.10.5.1
Table 103 on page 527 lists the show ip dhcp-local excluded command output fields.

Table 103: show ip dhcp-local excluded Output Fields

Field Name
Pool
Low Address
Chapter 22: Monitoring and Troubleshooting DHCP
High
Address
Field Description
Name of the pool that contains the excluded address
Excluded address or first address in a range of addresses
527