JunosE 11.2.x Broadband Access Configuration Guide
598
Figure 22: Subscriber Interfaces Using a Destination Address to
Demultiplex Traffic
To configure the static subscriber interfaces shown in Figure 22 on page 598, perform the
following steps:
Configure a primary IP interface on a supported layer 2 interface.
1.
a.
Create a layer 2 interface.
host1(config)#interface fastEthernet 3/1
b.
Create a primary IP interface.
host1(config-if)#ip address 10.1.1.1 255.0.0.0
c.
Configure the primary interface to use a destination address to demultiplex
traffic. (By default, a source address is used to demultiplex traffic.)
host1(config-if)#ip demux-type da-prefix
d.
Exit Interface Configuration mode.
host1(config-if)#exit
Configure subscriber interface IP1.
2.
a.
Create the shared IP interface.
Copyright © 2010, Juniper Networks, Inc.