Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 266

JunosE 11.2.x Broadband Access Configuration Guide
Agent-Circuit-Id [26-1]
Agent-Remote-Id [26-2]
Actual-Data-Rate-Upstream [26-129]
Actual-Data-Rate-Downstream [26-130]
Minimum-Data-Rate-Upstream [26-131]
Minimum-Data-Rate-Downstream [26-132]
Attainable-Data-Rate-Upstream [26-133]
Attainable-Data-Rate-Downstream
[26-134]
Maximum-Data-Rate-Upstream [26-135]
radius include dsl-forum-attributes
228
The router receives data containing one or more of the DSL Forum VSAs from a DSLAM
connected to the router via a PPPoE interface. When you enable the inclusion of the DSL
Forum VSAs in these RADIUS messages, the router includes all of the following attributes
in the specified message type, provided that the VSA is available in the information that
the router receives from the DSLAM.
NOTE: The router uses the vendor ID assigned to the DSL Forum (3561, or DE9 in
hexadecimal format) by the Internet Assigned Numbers Authority (IANA) for the DSL
Forum VSAs.
Maximum-Data-Rate-Downstream [26-136]
Minimum-Data-Rate-Upstream-Low-Power
[26-137]
Minimum-Data-Rate-Downstream-Low-Power
[26-138]
Maximum-Interleaving-Delay-Upstream [26-139]
Actual-Interleaving-Delay-Upstream [26-140]
Maximum-Interleaving-Delay-Downstream [26-141]
Actual-Interleaving-Delay-Downstream [26-142]
Access-Loop-Encapsulation [26-144]
IWF-Session [26-254]
For information about enabling the QoS downstream rate application to obtain
downstream rates from the Actual-Data-Rate-Downstream [26-130] DSL Forum VSA,
see the Configuring the Downstream Rate Using QoS Parameters chapter in JunosE Quality
of Service Configuration Guide.
For a more detailed description of the DSL Forum VSAs, see "DSL Forum VSAs" on page 267
.
Use to include the set of DSL Forum VSAs in Access-Request, Acct-Start, and Acct-Stop
messages that the router sends to RADIUS. If you enable inclusion of the DSL Forum
VSAs in Acct-Stop messages, the router also includes the VSAs in Interim-Acct
messages.
You can control inclusion of the DSL Forum VSAs in the specified message type by
enabling or disabling this command. Inclusion is disabled by default.
Copyright © 2010, Juniper Networks, Inc.