Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 277

radius disconnect client
radius dynamic-request server
subscriber disconnect
udp-port
Copyright © 2010, Juniper Networks, Inc.
Use to configure a RADIUS disconnect client and enter RADIUS Configuration mode.
Include the IP address of the RADIUS server that is acting as the disconnect client.
Example
host1(config)#radius disconnect client 10.10.5.10
host1(config-radius)#
Use the no version to remove the RADIUS disconnect client.
NOTE: The function of this command has been replaced by a combination of the RADIUS
dynamic-request server feature and the subscriber disconnect command. This command
might be removed completely in a future release.
See radius disconnect client
Use to configure a RADIUS dynamic-request server and enter RADIUS Configuration
mode. Specify the IP address of the RADIUS server that exchanges messages with the
RADIUS dynamic-request server.
Example
host1(config)#radius dynamic-request server 10.10.5.10
host1(config-radius)#
Use the no version to unconfigure the RADIUS dynamic-request server.
See radius dynamic-request server
Use to enable the RADIUS dynamic-request server to receive RADIUS disconnect
messages from a RADIUS server.
Example
host1(config-radius)#subscriber disconnect
Use the no version to disable processing of disconnect packets.
NOTE: This command and the RADIUS dynamic-request server feature replace the
radius disconnect client command, which may be removed completely in a future
release. The RADIUS Disconnect Configuration mode is also deprecated.
See subscriber disconnect
Chapter 4: Configuring RADIUS Dynamic-Request Server
239