Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 462

JunosE 11.2.x Broadband Access Configuration Guide
424
Table 83: show l2tp Output Fields (continued)
Field Name
Tunnel switching
Retransmission retries for
established tunnels
Retransmission retries for
not-established tunnels
Tunnel idle timeout
Failover within a preference level
Weighted load balancing
Tunnel authentication challenge
Calling number avp
Reject remote transmit address
change
Ignore remote transmit address
change
Disconnect-cause avp generation
Default receive window size
Rx speed avp when equal
Destination lockout timeout
Destination lockout test
Failover resync
Sub-interfaces
total
active
Field Description
Enabled or disabled
Number of retries configured for established tunnels
Number of retries configured for tunnels not
established
Length of the tunnel idle timeout, in seconds
Enabled or disabled
Enabled or disabled
Enabled or disabled
Whether the E Series LAC sends Calling-Station-Id
and Called-Station-Id AVPs in ICRQ packets, enabled
or disabled
Enabled or disabled for IP address, UDP port, or both
Enabled or disabled for IP address, UDP port, or both
Enabled or disabled
Default L2TP RWS for a tunnel on both the LAC and
the LNS; displays either the configured value or the
default behavior, indicated by system chooses
Enabled or disabled
Number of seconds that L2TP destinations remain in
the lockout state after they become unavailable
Status of the L2TP destination lockout test, enabled
or disabled
Global L2TP peer resynchronization configuration
Sub-interface information about L2TP
Number of destinations, tunnels, and sessions that
the router created
Number of operational destinations, tunnels, and
sessions
Copyright © 2010, Juniper Networks, Inc.