Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 245

aaa intf-desc-format include
radius include nas-port-id
radius override nas-port-id remote-circuit-id
Related Topics
Copyright © 2010, Juniper Networks, Inc.
NOTE: For subscribes connected over the LAG interface in DHCP standalone
authenticate mode, RADIUS uses the LAG interface ID for the Nas-Port-Id attribute.
For more information about subscribers connected over the LAG interface in DHCP
standalone authenticate mode, see "Propagation of LAG Subscriber Information to
AAA and RADIUS" on page 89.
Use to specify whether the router includes the subinterface number or adapter in the
interface description it passes to RADIUS for inclusion in the NAS-Port-Id attribute. By
default, the subinterface and adapter are sent (the commands are enabled).
Examples
host1#aaa intf-desc-format include sub-intf disable
host1#aaa intf-desc-format include adapter enable
Use the no version to remove the configuration.
See aaa intf-desc-format include
Use to include the NAS-Port-Id attribute in the Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the NAS-Port-Id attribute by enabling or disabling this
command.
See radius include
Example
host1(config)#radius include nas-port-id access-request enable
Use the no version to restore the default, enable.
Use to configure RADIUS to override the standard use of the NAS-Port-Id attribute
and instead use the remote circuit ID transmitted from a DSLAM device.
See radius override nas-port-id remote-circuit-id
Example
host1(config)#radius override nas-port-id remote-circuit-id
Use the no version to restore the default NAS-Port-ID value, which is the physical
interface of the NAS that is authenticating the user.
Monitoring Override Settings of RADIUS IETF Attributes on page 297
Monitoring the NAS-Port-ID RADIUS Attribute on page 301
Chapter 3: Configuring RADIUS Attributes
207