Table of Contents
Advertisement
JunosE 11.2.x Broadband Access Configuration Guide
L2TP References
336
For more information about L2TP, see the following resources:
RFC 2661—Layer Two Tunneling Protocol " L2TP" (August 1999)
RFC 3145—L2TP Disconnect Cause Information (July 2001)
Fail Over extensions for L2TP " failover" —draft-ietf-l2tpext-failover-06.txt (April 2006
expiration)
RFC 4951—Fail Over Extensions for Layer 2 Tunneling Protocol (L2TP) "failover" (August
2007)
For information about L2TP high availability support, see the Managing High Availability
chapter in JunosE System Basics Configuration Guide.
For information about setting up policy-based routing features for L2TP, such as rate
limit profiles, classifier control lists, and policy lists, see the JunosE Policy Management
Configuration Guide.
For information about creating and attaching QoS profiles to L2TP sessions, see the
JunosE Quality of Service Configuration Guide.
For information about how to secure Layer 2 Tunneling Protocol (L2TP) tunnels with IP
Security (IPSec) on your E Series router, see the Securing L2TP and IP Tunnels with IPSec
chapterin JunosE IP Services Configuration Guide.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
