radius include acct-authentic
radius include acct-terminate-cause
Copyright © 2010, Juniper Networks, Inc.
NOTE: For subscribes connected over the LAG interface in DHCP standalone
authenticate mode, the LAG interface ID is used as the interface identifier. For more
information about subscribers connected over the LAG interface in DHCP standalone
authenticate mode, see "Propagation of LAG Subscriber Information to AAA and
RADIUS" on page 89.
decimal—Configures the RADIUS client to use a decimal format. For example: 435264
See radius acct-session-id-format
Example
host1(config)#radius acct-session-id-format decimal
Use the no version to negate the Acct-Session-Id format.
[45] Acct-Authentic
Use the following command to manage the Acct-Authentic RADIUS attribute.
radius include acct-authentic
Use to include the Acct-Authentic attribute in Acct-On or Acct-Off messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include acct-authentic acct-on enable
Use the no version to restore the default, enable.
[49] Acct-Terminate-Cause
Use the following command to manage the Acct-Terminate-Cause RADIUS attribute.
radius include acct-terminate-cause
Use to include the Acct-Terminate-Cause attribute in Acct-Off messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include.
Example
host1(config)#radius include acct-terminate-cause acct-off disable
Use the no version to restore the default, enable.
Chapter 3: Configuring RADIUS Attributes
199