Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 464

JunosE 11.2.x Broadband Access Configuration Guide
Related Topics
426
Table 84: show l2tp destination Output Fields (continued)
Field Name
Administrative state
SNMP traps
Destination address
Transport
Virtual
Local and peer addresses
Destination status
Sub-interfaces
total
active
failed
auth-errors
Statistics
show l2tp destination
Field Description
Administrative status of the destination:
enabled—No restrictions on creation and operation
of sessions and tunnels for this destination
disabled—Router disabled existing sessions and
tunnels and will not create new sessions or tunnels
for this destination
drain—Router will not create new sessions or
tunnels for this destination
Whether or not the router sends traps to SNMP for
operational state changes
Address information for the specified destination
Method used to transfer traffic
Name of the virtual router on which the tunnel is
configured
Addresses of the local and remote interfaces
Effective administrative state—The more restrictive
of the router and destination administrative states.
This setting, rather than the administrative state of
the destination, determines whether the router can
create new sessions or tunnels and whether the
sessions or tunnels are disabled for this destination.
Sub-interface information about the L2TP destination
Number of sessions or tunnels that the router created
for this destination
Number of operational sessions or tunnels for this
destination
Number of requests that did not reach an operational
state for this destination
Number of requests that failed because the tunnel
password was invalid for this destination
Information about the traffic sent and received
Copyright © 2010, Juniper Networks, Inc.