Service Manager Platform Considerations; Service Manager References; Service Manager Configuration Tasks - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Software for e series broadband services routers broadband access configuration guide
Table of Contents

Advertisement

Service Manager Platform Considerations

Service Manager References

Service Manager Configuration Tasks

Copyright © 2010, Juniper Networks, Inc.
Table 138: Service Manager Terms and Acronyms (continued)
Term
Service instance
Service session
Service session profile
Service Manager is supported on all E Series routers. For information about the modules
supported on E Series routers:
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx models,
and the ERX310 Broadband Services Router.
See the E120 and E320 Module Guide for modules supported on the E120 and E320
Broadband Services Routers.
For more information about the topics covered in this chapter, see the following
documents:
Data-Over-Cable Service Interface Specifications (DOCSIS) 2.0 Radio Frequency
Interface Specification CM-SP-RFIv2.0-I10-051209.
For information about using the JunosE Software's macro language, see the Writing
CLI Macros chapter in JunosE System Basics Configuration Guide.
For information about setting up policy-based routing features for Service Manager,
such as rate-limit profiles, classifier control lists, policy lists, and hierarchical and
merged policies, see the JunosE Policy Management Configuration Guide.
For information about creating QoS profiles and QoS parameters, see the JunosE Quality
of Service Configuration Guide.
For information about creating IPv4 interface profiles, see the Configuring IP chapter
in JunosE IP, IPv6, and IGP Configuration Guide.
To use the Service Manager application to create subscriber service sessions, you perform
the following tasks:
Create and manage service definitions
Chapter 27: Configuring Service Manager
Definition
An instance that is created when you specify parameter values
for a service definition to create a service session
A session that is created when a service instance is activated for
a subscriber; a subscriber can have multiple active service sessions
A provider-configured profile that applies optional attributes to
a service session; CLI only
625

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents