Table 39: AAA Accounting Message RADIUS IETF Attributes
Supported (continued)
Attribute
Number
Attribute Name
[97]
Framed-Ipv6-Prefix
(See Note 5.)
[99]
Framed-IPv6-Route
[100]
Framed-IPv6-Pool
[123]
Delegated-Ipv6-Prefix
[188]
Ascend-Num-In-Multilink
(See Note 3.)
Supported Juniper Networks VSAs
Copyright © 2010, Juniper Networks, Inc.
Acct-Start
Table 40 on page 178 lists the Juniper Networks (Vendor ID 4874) VSAs supported for
Acct-Start, Acct-Stop, Interim-Acct, Acct-On, Acct-Off, Partition-Accounting-On, and
Partition-Accounting-Off messages.
The following notes are referred to in Table 40 on page 178:
The attribute is not included in Acct-Stop messages that are sent when a user session
1.
does not get established in one of the following situations.
The aaa accounting acct-stop on-access-deny command is enabled and the
authentication server sends an Access-Reject (deny) message.
The aaa accounting acct-stop on-aaa-failure command is enabled and the
authentication server issues an Access-Accept message (grant), but the AAA
configuration denies access for the user. The aaa accounting acct-stop
on-aaa-failure is enabled by default.
The aaa accounting acct-stop on-aaa-failure command is enabled and the user
terminates before AAA receives the authentication response from the
authentication server.
ERX routers send IPv6 accounting attributes in the Acct-Stop and Interim-Acct
2.
messages (stop, interim) when they are configured to return these attributes and
when the subscriber is either an IPv6 subscriber or a combined IPv4/IPv6 subscriber
in a dual stack. For an IPv4 subscriber, IPv6 accounting attributes are not included
in the accounting messages even if the IPv6 accounting is enabled.
In JunosE Release 10.1.x and lower-numbered releases, the combined accounting
statistics were retrieved at the layer 2. Therefore, error or discarded packets in the
layer 2 itself were excluded in these statistics. Because the layer 2 cannot detect the
error or discarded packets in the layer 3, the combined statistics also include the
error or discarded packets of the layer 3. In this release, with the support for RADIUS
Chapter 3: Configuring RADIUS Attributes
Acct-Stop
Interim-Acct
Acct-On
Acct-Off
–
–
–
–
–
–
–
–
–
–
177