[26-24] Pppoe-Description; [26-35] Acct-Input-Gigapackets; [26-36] Acct-Output-Gigapackets - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

radius include pppoe-description
radius include input-gigapkts
radius include output-gigapkts
Copyright © 2010, Juniper Networks, Inc.
host1(config)#radius ignore atm-mbs enable
Use the no version to restore the default, disable.

[26-24] Pppoe-Description

Use the following command to manage the Pppoe-Description RADIUS attribute.
radius include pppoe-description
Use to include the Pppoe-Description attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the Pppoe-Description attribute by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include pppoe-description acct-start enable
Use the no version to restore the default, enable.

[26-35] Acct-Input-Gigapackets

Use the following command to manage the Acct-Input-Gigapackets RADIUS attribute.
radius include input-gigapkts
Use to include Acct-Input-Gigapackets in Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
see radius include
Example
host1(config)#radius include input-gigapkts acct-stop disable
Use the no version to restore the default, enable.

[26-36] Acct-Output-Gigapackets

Use the following command to manage the Acct-Output-Gigapackets RADIUS attribute.
radius include output-gigapkts
Use to include the Acct-Output-Gigapackets attribute in Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Chapter 3: Configuring RADIUS Attributes
215