Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 68

JunosE 11.2.x Broadband Access Configuration Guide
max-sessions
no radius client
radius accounting server
30
This command applies to PPP users, as well as to non-PPP DHCP users.
Example
host1#logout subscribers username bmurphy
There is no no version.
See logout subscribers
Use to configure the number of outstanding requests supported by an authentication
or accounting server.
If the request limit is reached, the router sends the request to the next server.
NOTE: For information about the number of concurrent RADIUS requests that the router
supports for authentication and accounting servers, see JunosE Release Notes, Appendix
A, System Maximums.
The same IP address can be used for both an authentication and accounting server
(but not for multiple servers of the same type). The router uses different UDP ports
for authentication servers and accounting servers.
For each multiple of 255 requests (the RADIUS protocol limit), the router opens a new
UDP source (or local) port on the server to send and receive RADIUS requests and
responses.
Example
host1(config)#radius authentication server 10.10.0.1
host1(config-radius)#max-sessions 100
Use the no version to restore the default value, 255.
See max-sessions.
Use to remove all RADIUS servers for the virtual router context and to delete the E Series
RADIUS client for the virtual router context.
Example
host1:boston(config)#no radius client
There is no affirmative version of this command; there is only a no version.
See no radius client
Use to specify the IP address of authentication and accounting servers.
Example
host1(config)#radius authentication server 10.10.10.1
Copyright © 2010, Juniper Networks, Inc.