JunosE 11.2.x Broadband Access Configuration Guide
Table 72: Tunnel--Tx-Speed-Method RADIUS Attribute
Attribute
Number
Attribute Name
[26-94]
Tunnel-Tx-Speed-Method
Related Topics
PPP Accounting Statistics
398
Description
The method that the router
uses to calculate the transmit
connect speed of the
subscriber's access interface
Transmit Connect Speed Calculation Methods on page 391
Using AAA Domain Maps to Configure the Transmit Connect Speed Calculation Method
on page 395
Using AAA Tunnel Groups to Configure the Transmit Connect Speed Calculation Method
on page 395
Using AAA Default Tunnel Parameters to Configure the Transmit Connect Speed
Calculation Method on page 396
Using RADIUS to Configure the Transmit Connect Speed Calculation Method on page 397
aaa tunnel tx-connect-speed-method
tx-connect-speed-method
JunosE accounting for tunneled subscribers at the L2TP LAC counts the payload that
PPP passes to or receives from L2TP for transport. At this stage in the protocol processing,
any padding outside PPP, such as that for PPPoE, has been removed. Accounting includes
the authentication acknowledgement packet, CHAP success packets, and PAP
acknowledgment packets. Accounting ends when L2TP has been notified to terminate
the session. The statistics are reported in the following RADIUS attributes:
Attribute Number
42
43
47
48
Subtype
Length
Length
Value
12
6
integer:
1 = static-layer2; TX speed based
on static layer 2 settings
2 =dynamic-layer2; TX speed
based on dynamic layer 2
settings
3 = qos; TX speed based on QoS
settings
4 = actual; TX speed that is the
lesser of the dynamic-layer2
value or the qos value
Attribute Name
Acct-Input-Octets
Acct-Output-Octets
Acct-Input-Packets
Acct-Output-Packets
Copyright © 2010, Juniper Networks, Inc.