Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 383

Copyright © 2010, Juniper Networks, Inc.
Slot ASCII
Number Character
3 3
4 4
5 5
6 6
7 7
8 8
For example, slot 16 is shown as the ASCII character uppercase G.
Example—The following command configures the L2TP Calling Number AVP in
fixed-adapter-embedded format:
host1(config)#aaa tunnel calling-number-format fixed-adapter-embedded
For example, when you configure this L2TP Calling Number AVP format on an E320
router for an ATM interface on system name eastern, slot 14, adapter 1, port 2, VCI 3,
and VPI 4, the virtual router displays the format in ASCII as 'E' '1' '2' '003' '00004'.
fixed-adapter-new-field—If you set up the router to generate the L2TP Calling Number
AVP in fixed–adapter-embedded-new-field format, the router formats the AVP to use
a fixed format of up to 17 characters consisting of all ASCII fields with a 2-byte slot
field, 1-byte adapter field, and 2-byte port field:
Format for ATM interfaces:
systemName (up to 4 bytes) slot (2 bytes) adapter (1 byte)
port (2 bytes) VPI (3 bytes) VCI (5 bytes)
Format for Ethernet interfaces:
systemName (up to 4 bytes) slot (2 bytes) adapter (1 byte)
port (2 bytes) VLAN (8 bytes)
Format for serial interfaces:
systemName (up to 4 bytes) slot (2 bytes) adapter (1 byte)
port (2 bytes) 0 (8 bytes)
Slot numbers 0 through 16 are shown as integers in the 2-byte slot field.
Example—The following command configures the L2TP Calling Number AVP in
fixed-adapter-new-field format:
host1(config)#aaa tunnel calling-number-format fixed-adapter-new-field
For example, when you configure this L2TP Calling Number AVP format on an E320
router for an ATM interface on system name eastern, slot 14, adapter 1, port 2, VCI 3,
and VPI 4, the virtual router displays the format in ASCII as '14' '1' '02' '003' '00004'.
Chapter 12: Configuring an L2TP LAC
Slot ASCII
Number Character
12 C
13 D
14 E
15 F
16 G
– –
345