Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 224

JunosE 11.2.x Broadband Access Configuration Guide
radius include nas-port
radius nas-port-format
radius nas-port-format extended atm
radius nas-port-format extended ethernet
186
NOTE: For subscribers connected over the LAG interface in DHCP standalone
authenticate mode, RADIUS derives a unique value from the subscriber's profileHandle
and uses the value for the Nas-Port attribute. The radius nas-port-format, radius vlan
nas-port-format stacked, and radius pppoe nas-port-format commands do not affect
the value of the Nas-Port attribute.
For more information about subscribers connected over the LAG interface in DHCP
standalone authenticate mode, see "Propagation of LAG Subscriber Information to
AAA and RADIUS" on page 89.
Use to include the NAS-Port attribute in Access-Request, Acct-Start, and Acct-Stop
messages.
You control inclusion of the attribute by enabling or disabling this command.
Example
host1(config)#radius include nas-port acct-start enable
Use the no version to restore the default, enable.
See radius include
Use to set the NAS-Port format attribute for ATM and Ethernet only to either 0ssssppp
or ssss0ppp.
The format is a 4-octet integer. The remaining bits are not changed (8 bits VPI and 16
bits VCI; or 12 bits S-VLAN and 12 bits VLAN).
The s indicates a bit used to represent the slot; the p indicates a bit used to represent
the port from which the authentication request originates.
See radius nas-port-format
Example: If the PPP user is received on a VC from the card in slot 7, port 2, then the bit
pattern is either 00111010 (for 0ssssppp) or 01110010 (for ssss0ppp).
host1(config)#radius nas-port-format Ossssppp
Use the no version to restore the default.
Use to set the NAS-Port format attribute for ATM, Gigabit Ethernet, and 10-Gigabit
Ethernet interfaces on the E120 and E320 routers only.
The format attribute set using the radius nas-port-format command does not
accommodate the number of bits required by the ATM interface specifier
(slot/adapter/port/vpi/vci) or the Gigabit Ethernet and 10-Gigabit Ethernet interface
specifier [ slot/adapter/port ] [ .vlanSubinterface ]. Issuing this command enables you
Copyright © 2010, Juniper Networks, Inc.