Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 81

operational-virtual-router
password
Copyright © 2010, Juniper Networks, Inc.
Use to specify the IP address pool parameter for a user entry in the local user database.
The address pool is used to assign an IP address to the subscriber; the address is
negotiated with the subscriber after the subscriber is authenticated.
Example
host1(config-local-user)#ip-address-pool svPool2
Use the no version to delete the IP address pool parameter from the user entry in the
local user database.
See ip address-pool
Use to specify the virtual router parameter for a user entry in the local user database.
The subscriber is assigned to the operational virtual router only if the default virtual
router performs the authentication.
If authentication is performed by a non-default virtual router, then the subscriber is
assigned to the same virtual router that performs authentication, regardless of this
parameter setting.
Example
host1(config-local-user)#operational-virtual-router boston2
Use the no version to delete the operational virtual router parameter from the user
entry in the local user database.
See operational-virtual-router
Use to add a password to a user entry in the local user database. The password is used
to authenticate a subscriber, and is encrypted by means of a two-way encryption
algorithm.
NOTE: CHAP authentication requires that passwords and secrets be stored in clear
text or use two-way encryption. Two-way encryption is not supported for the secret
command. Therefore, use the password command if you want to enable encryption for
subscribers that use CHAP authentication.
The new password replaces any current password or secret.
Specify one of the following encryption algorithms, followed by the password:
0—An unencrypted password; this is the default
8—A two-way encrypted password
Example
host1(config-local-user)#password 0 myPassword
Chapter 1: Configuring Remote Access
43