Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 702

JunosE 11.2.x Broadband Access Configuration Guide
time
volume
664
NOTE: Service Manager statistics collection is a three-part procedure. You must
configure statistics information in the service definition macro file, enable statistics
collection by either RADIUS or the CLI, and also enable statistics collection for the policy
referenced in the service macro using the statistics enabled keyword in the command
used for policy attachment in the profile. See "Configuring Service Manager Statistics"
on page 667.
See statistics
Use to specify the maximum amount of time that the service session can be active for
the subscriber.
The router immediately terminates the subscriber's service session when the specified
time is exceeded.
The range is 0–16777251 seconds.
Example
host1(config)#service-management service-session-profile vodISP1
host1(config-service-session-profile)#time 6000
Use the no version to delete the time attribute from the service session profile.
See time
Use to specify the maximum amount of bandwidth that can use the service.
The router immediately terminates the subscriber's service session when the specified
traffic volume is exceeded.
NOTE: The volume attribute uses values captured by the Service Manager statistics
feature to determine when the threshold is exceeded. Therefore, you must configure
and enable statistics collection to use this attribute. See "Configuring Service Manager
Statistics" on page 667.
The range is 0–16777251MB.
Example
host1(config)#service-management service-session-profile vodISP1
host1(config-service-session-profile)#volume 1000000
Use the no version to delete the volume attribute from the service session profile.
See volume
Copyright © 2010, Juniper Networks, Inc.