Using Aaa Domain Maps To Configure The Transmit Connect Speed Calculation Method; Using Aaa Tunnel Groups To Configure The Transmit Connect Speed Calculation Method - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Using AAA Domain Maps to Configure the Transmit Connect Speed Calculation Method

Using AAA Tunnel Groups to Configure the Transmit Connect Speed Calculation Method

Copyright © 2010, Juniper Networks, Inc.
if configured with the vlan advisory-tx-speed command, takes precedence over the
physical port speed of the underlying layer 2 ATM 1483 interface. As a result, if the advisory
transmit speed is configured for the VLAN subinterface, L2TP reports this value as the
transmit connect speed regardless of the port speed of the ATM 1483 interface.
To configure the transmit connect speed calculation method for a tunneled L2TP session
associated with an AAA domain map:
Access Domain Map Tunnel Configuration mode.
1.
host1(config)#aaa domain-map sunnyvale.com
host1(config-domain-map)#router-name lac
host1(config-domain-map)#tunnel 5
host1(config-domain-map-tunnel)#
For more information about how to map a domain to an L2TP tunnel from Domain
Map Tunnel Configuration mode, see "Mapping a User Domain Name to an L2TP
Tunnel Overview" on page 351 .
From Domain Map Tunnel Configuration mode, configure the calculation method
2.
for the transmit connect speed of the subscriber's access interface.
host1(config-domain-map-tunnel)#tx-connect-speed-method dynamic-layer2
(Optional) Use the show aaa domain-map command to verify configuration of the
3.
transmit connect speed calculation method.
host1(config-domain-map-tunnel)#run show aaa domain-map
Domain: sunnyvale.com; router-name: lac; ipv6-router-name: default
Tunnel Tunnel
Tag Peer
------ ------
5 <null>
Tunnel
Tunnel Server
Tag Name
------ ------
5 <null>
Tunnel
Tunnel Failover
Tag Resync
------ --------
5 <null>
To configure the transmit connect speed calculation method for a tunneled L2TP session
associated with an AAA tunnel group:
Access Tunnel Group Tunnel Configuration mode.
1.
host1(config)#aaa tunnel-group boston
host1(config-tunnel-group)#tunnel 3
host1(config-tunnel-group-tunnel)#
Tunnel Tunnel Tunnel
Source Type Medium
------ ------ ------
<null> l2tp ipv4
Tunnel
Tunnel Max
Preference Sessions
---------- --------
2000 0
Tunnel Tunnel
Switch Tx
Profile Speed Method
------- --------------
<null> dynamic layer2
Chapter 13: Configuring an L2TP LNS
Tunnel
Tunnel Tunnel Client
Password Id
-------- ------ ------
<null> <null> <null>
Tunnel
Virtual
Tunnel RWS Router
-------------- -------
system chooses <null>
Name
395