Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 136

JunosE 11.2.x Broadband Access Configuration Guide
sscc transportRouter
sscc option
sscc update-policy-request enable
98
Use the no version to remove the source interface.
See sscc sourceInterface
Use to specify on which router the TCP/COPS connection is to be established.
The router can be the same as or different from the router the SRC client session is
created in and associated with.
If you do not specify the transport router for an SRC client session, the transport router
defaults to the router associated with the session.
Example
host1(config)#sscc transportRouter chicago
Use the no version to remove the specified SRC client transport router.
See sscc transportRouter
Use to send either the user IP address mask instead of the interface IP address mask
, the calling station ID, or the local QoS profile attachment information to a Policy
Decision Point (PDP).
Example
host1(config)#sscc option user-ip-mask-override
host1(config)#sscc option send-calling-station-id
host1(config)#sscc option send-local-qos-profile-config
Use the no version to remove the specified
and
send-local-qos-profile-config
See sscc option
Use to enable updated DSL line rate parameters to be collected from ANCP and
transmitted to the COPS server with the corresponding COPS messages.
The SRC client gathers line rate information from the access node and transfers it to
the COPS sever, both during connection establishment between a subscriber and an
access node, and when any of the values of the line rate parameters changes after the
connection is built.
A COPS server that is running SRC software Release 3.0.0 and earlier releases does
not support the receipt of updated DSL line rate information from the SRC client. If
you configure the SRC client to send updated line rate parameters to the COPS server,
regardless of the version of SRC software that it is running, the COPS server ignores
the received updated line rate information and processes the other COPS details.
Therefore, this feature of retrieval of updated line rate parameters from ANCP by the
SRC client is backward compatible with older versions of SRC software.
user-ip-mask-override
.
Copyright © 2010, Juniper Networks, Inc.
, ,
send-calling-station-id