Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 648

JunosE 11.2.x Broadband Access Configuration Guide
encapsulation bridge1483
encapsulation vlan
interface atm
interface fastEthernet
610
host1(config-dhcp-local)#default-router 10.10.1.1
Use the no version to remove the association between the address pool and the router.
See default-router
Use to configure bridged Ethernet as the encapsulation method on an interface.
Example
host1(config-subif)#encapsulation bridge1483
Use the no version to remove bridged Ethernet as the encapsulation method on the
interface.
See encapsulation bridge1483
Use to configure VLAN as the encapsulation method on an interface.
Issuing this command creates the VLAN major interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to disable VLAN encapsulation on the interface.
See encapsulation vlan
Use to configure an ATM interface or subinterface type in the slot/port.subinterface
format:
slot—Specifies router chassis slot
port—Specifies I/O module port
subinterface—Specifies subinterface number
Example
host1(config-if)#interface atm 9/1.1
Use the no version to remove the ATM interface or subinterface.
See interface atm
Use to select a Fast Ethernet (FE) interface on a line module or an SRP module.
Example
host1(config)#interface fastEthernet 1/0
Copyright © 2010, Juniper Networks, Inc.