Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 82

JunosE 11.2.x Broadband Access Configuration Guide
secret
user-name
44
Use the no version to delete the password or secret from the user entry in the local
user database.
See password
Use to add a secret to a user entry in the local user database. The secret is used to
authenticate a subscriber, and is encrypted by means of the Message Digest 5 (MD5)
encryption algorithm.
NOTE: CHAP authentication requires that passwords and secrets be stored in clear
text or use two-way encryption. Two-way encryption is not supported for the secret
command. Therefore, use the password command if you want to enable encryption for
subscribers that use CHAP authentication.
The new secret replaces any current password or secret.
Specify one of the following encryption algorithms, followed by the secret:
0—An unencrypted secret; this is the default
5—An MD5-encrypted secret
Example
host1(config-local-user)#secret 5 Q3&t9REwk45jxSM#fj$z
Use the no version to delete the secret or password from the user entry in the local
user database.
See secret
Use to configure a user entry and optional password or secret in the default local user
database. This command creates the database if it does not already exist.
Optionally, specify a password or secret that is assigned to the user in the default local
user database, or specify that no password is required for the particular username.
Specify one of the following encryption algorithms, followed by the password:
0—An unencrypted password; this is the default
8—A two-way encrypted password
Specify one of the following encryption algorithms, followed by the secret:
0—An unencrypted secret; this is the default
5—An MD5-encrypted secret
Use the nopassword keyword to remove the password or secret
Copyright © 2010, Juniper Networks, Inc.