Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 135

sscc retryTimer
sscc sourceAddress
sscc sourceInterface
Copyright © 2010, Juniper Networks, Inc.
Example
host1#sscc restart clean-state
There is no no version.
See sscc restart
Use to specify the delay period (in the range 5–300 seconds) during which the SRC
client waits for a response from the SAE.
If only a primary SAE is configured, the client resends the request to the primary SAE.
The client attempts to connect to a tertiary SAE only if both the primary and secondary
SAEs are unavailable. For example, if the client is connected to the secondary SAE
when the delay period expires, the client first tries to connect to the primary SAE before
trying the tertiary SAE. The client waits for the length of the delay period before each
attempt.
Example
host1(config)#sscc retryTimer 90
Use the no version to restore the default value, 90 seconds.
See sscc retryTimer
Use to specify a fixed source address for the TCP/COPS connection created for an
SRC client session. This is the local address.
If you do not specify a source address, the TCP/COPS connection is not bound to a
specific source (that is, local) address.
Example
host1(config)#sscc sourceAddress 10.9.123.8
Use the no version to remove the specified address.
See sscc sourceAddress
Use to specify a fixed source interface for the TCP/COPS connection created for an
SRC client session. This is a local interface.
You may need to set a source interface in cases where a firewall, access control list,
or policy configuration exists; and it is important to know what the interface is, or you
need to set the interface independently from other protocols that have conflicting
requirements.
If you do not specify a source interface, the TCP/COPS connection is not bound to a
specific source (that is, local) interface.
Example
host1(config)#sscc sourceInterface atm 3/0
Chapter 1: Configuring Remote Access
97