Table of Contents
Advertisement
profile
qos-profile
Copyright © 2010, Juniper Networks, Inc.
You can modify the QoS profile by modifying configurations referenced by the QoS profile,
including QoS parameter instances. You can also attach a new QoS profile when activating
a service, but make sure that the QoS profile is attached to the subscriber's interface.
For more information about configuring QoS profiles, see the Configuring and Attaching
QoS Profiles to an Interface chapter in JunosE Quality of Service Configuration Guide.
Configuring a QoS Profile for Service Manager
To configure a QoS profile for Service Manager:
Configure the profile.
1.
host1(config)#profile videoService
Configure the QoS profile.
2.
host1(config-profile)#qos-profile videoBandwidth1
(Optional) Complete the QoS profile configuration described in the Configuring and
3.
Attaching QoS Profiles to an Interface chapter in JunosE Quality of Service Configuration
Guide.
Use to create a profile and enter Profile Configuration mode.
You specify a profile name with up to 80 alphanumeric characters.
Example
host1(config)#profile iptv
host1(config-profile)#
Use the no version to remove a profile.
See profile
Use to add a QoS profile command for use with Service Manager. When the service is
activated, the QoS profile is created and attached to the subscriber interface.
Example
host1(config)#profile iptv
host1(config-profile)#qos-profile video
Use the no version to remove the QoS profile from the profile.
See qos-profile
Specifying QoS Profiles in a Service Definition
After you configure a QoS profile for Service Manager, you can reference it in a service
definition. For example:
profile <# eastcoast ; '\n' #>
qos-profile <# video; '\n' #>
Chapter 27: Configuring Service Manager
633
Advertisement
Table of Contents
Troubleshooting
