Configuring L2Tp Dial-Out - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

Configuring L2TP Dial-Out

l2tp dial-out connecting-timer-value
Copyright © 2010, Juniper Networks, Inc.
Specify the interface used for dialout.
2.
host1(config-profile)#ip unnumbered loopback 0/0
Specify the virtual router for the dial-out user's IP interface.
3.
host1(config-profile)#ip virtual-router lns
Specify the authentication mechanism.
4.
host1(config-profile)#ppp authentication chap
To configure L2TP dial-out:
Enable the creation of a dial-out session.
1.
host1(config)#l2tp dial-out target 10.10.0.0 255.255.0.0 L2TP-dial-out.de.dt profile
dialOut
(Optional) Set the maximum time allowed for successful establishment of an L2TP
2.
dial-out session.
host1(config)#l2tp dial-out connecting-timer-value 30
(Optional) Set how long the dial-out session stays in the dormant state waiting for
3.
a new trigger after the associated L2TP outgoing call ends.
host1(config)#l2tp dial-out dormant-timer-value 300
(Optional) Set the maximum number of trigger packets held in buffer while the
4.
dial-out session is being established.
host1(config)#l2tp dial-out max-buffered-triggers 50
You can also:
Manually delete a dial-out session.
host1#l2tp dial-out session delete 10.10.0.0
Reset a dial-out session by forcing it to the dormant state.
host1#l2tp dial-out session reset 10.10.0.0
Use to set the maximum time allowed for attempts to establish L2TP dial-out sessions.
If the session fails to be established before the connecting timer expires, subsequent
attempts to establish the dial-out session to the same destination are inhibited
temporarily.
The range is 30–3600 seconds.
Example
host1(config)#l2tp dial-out connecting-timer-value 30
Chapter 14: Configuring L2TP Dial-Out
409