Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 63

aaa accounting duplication
aaa accounting immediate-update
aaa accounting interval
Copyright © 2010, Juniper Networks, Inc.
NOTE: IP subscriber management interfaces are static or dynamic interfaces that are
created or managed by the JunosE Software's subscriber management feature.
Although the atm1483 keyword is available in the CLI for this command, that subscriber
type is not supported. The router does not support accounting for ATM 1483 subscribers.
Specify one of the following types of accounting methods:
radius—RADIUS accounting for the specified subscribers.
none—No accounting is done for the specified subscribers.
radius none—Multiple types of accounting; used in the order specified. For example,
radius none specifies that RADIUS accounting is initially used; however, if RADIUS
servers are not available, no accounting is done.
Example
host1(config)#aaa accounting ppp default radius
Use the no version to set the accounting protocol to the default, radius.
See aaa accounting default
Use to enable AAA duplicate accounting on a virtual router. Specifies that duplicate
accounting records be sent to the accounting server on another virtual router.
Example
host1(config)#aaa accounting duplication routerBoston
Use the no version to disable the feature.
See aaa accounting duplication
Use to send an accounting update to the accounting server immediately on receipt of
a response for an Acct-Start message.
Use the enable keyword to enable immediate updates. Use the disable keyword to
disable immediate updates. Immediate updates are disabled by default.
Example
host1(config)#aaa accounting immediate-update enable
Use the no version to restore the default condition, disabling immediate updates.
See aaa accounting immediate-update
Chapter 1: Configuring Remote Access
25