Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 695

aaa service accounting interval
aaa user accounting interval
Copyright © 2010, Juniper Networks, Inc.
Table 149: Sample Acct-Start Message for a Service Session (continued)
RADIUS Attribute
service-interim-acct-interva
l
Use to specify the default interval between service accounting updates. Service manager
uses the default interval when no value is specified in the Service-Interim-Acct-Interval
attribute (Juniper VSA 26-140).
This command and the aaa user accounting interval command replace the aaa
accounting interval command, which is deprecated and might be removed in a future
release.
The default interval is applied on a virtual router basis—this setting is used for services
associated with all users who attach to the corresponding virtual router.
Specify the service accounting interval, in the range 10–1440 minutes. The default
setting is 0, which disables the feature.
NOTE: To enable interim service accounting, the service accounting interval must be
set to a non-zero value and the service statistics type must not be set to none.
Example
host1(config)#aaa service accounting interval 60
Use the no version to reset the accounting interval to 0, which turns off interim service
accounting when no value is specified in the Service-Interim-Acct-Interval attribute
(Juniper VSA 26-140).
See aaa service accounting interval
Use to specify the default interval between user accounting updates. The router uses
the default interval when no value is specified in the RADIUS Acct-Interim-Interval
attribute (RADIUS attribute 85).
This command and the aaa service accounting interval command replace the aaa
accounting interval command, which is deprecated and might be removed in a future
release.
The default interval is applied on a virtual router basis—this setting is used for all users
who attach to the corresponding virtual router.
Specify the user accounting interval, in the range 10–1440 minutes. The default setting
is 0, which disables the feature.
Example
host1(config)#aaa user accounting interval 20
Chapter 27: Configuring Service Manager
Sample Value
1200
657