Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 615

set ip interface-profile
set ip service-profile
set ip source-prefix
user-name
Copyright © 2010, Juniper Networks, Inc.
Use to specify the password for an IP service profile. The password is used as the
dynamically created password by JunosE subscriber management.
You can specify a password with up to 32 ASCII characters.
Example
host1(config-service-profile)#password mypassword
Use the no version to remove the password from the IP service profile.
See password
Use to specify a dynamic subscriber interface profile that is used in the route map.
Example
host1(config)#route-map mapForEPort
host1(config-route-map)#set ip interface-profile disableUser
Use the no version to delete the interface profile from the route map.
See set ip interface-profile
Use to specify the name of a subscriber's service profile that is used in the route map.
You can specify a service profile name with up to 32 ASCII characters.
Example
host1(config-route-map)#set ip service-profile yourServiceProfile
Use the no version to remove the service profile from the route map.
See set ip service-profile
Use to specify a source address range to be inserted into a specific interface, and the
action to take with the range.
deny—Drop addresses that appear in the source address range
primary—Associate the source prefix with the primary IP interface
Example
host1(config-route-map)#set ip source-prefix 10.10.30.0 255.255.255.0 primary
Use the no version to remove the source address range from the route map.
See set ip source-prefix
Use to specify the username for an IP service profile. The username is used as the
dynamically created username by JunosE subscriber management.
You can specify a username with up to 32 ASCII characters.
Chapter 23: Configuring Subscriber Management
577