Table of Contents
Advertisement
JunosE 11.2.x Broadband Access Configuration Guide
IP Hinting
aaa domain-map
ip-hint
ipv6-local-interface
10
attribute with the value set to 20 minutes, the router uses this idle timeout value unless
the RADIUS server configured in the VR context returns a different value.
Since the router supports the RADIUS User-Name attribute [1] in the RADIUS response
message, the default VR RADIUS server may override the user's name (this can be a
stripped name or an entirely different name). Overriding is useful for the case when the
user enters a login name containing a domain name that is significant only to the RADIUS
server in the default VR.
You can allocate an address before authentication of PPP sessions. This address is
included in the Access-Request sent to the authentication server as an IP address hint.
Use to map a user domain name to a virtual router or a loopback interface.
When you specify only the domain name, the command sets the mode to Domain Map
Configuration.
Example
host1(config)#aaa domain-map juniper.net vrouter_1
host1(config)#aaa domain-map none vrouter_all_purpose
host1(config)#aaa domain-map default vrouter_all_purpose
host1(config)#aaa domain-map 8005558934 vrouter_78
host1(config)#aaa domain-map westford.com
host1(config-domain-map)#
Use the no version to delete the map entry.
See aaa domain-map
Use to preallocate an IP address for the remote B-RAS user before authenticating the
remote user.
The address is passed as a hint in the authentication request.
Example
host1(config-domain-map)#ip-hint enable
Use the no version to disable the feature.
See ip-hint
Use to map a user domain name to an IP version 6 (IPv6) loopback interface.
The local interface identifies the interface information to use on the local (E Series)
side of the subscriber's interface.
Example
host1(config)#aaa domain-map westford.com
host1(config-domain-map)#ipv6-local-interface 2001:db8::8000
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
