JUNOSe 11.0.x Broadband Access Configuration Guide
NOTE: For subscribes connected over the LAG interface in DHCP standalone
authenticate mode, the LAG interface ID is used as the interface identifier. For more
information about subscribers connected over the LAG interface in DHCP standalone
authenticate mode, see "Propagation of LAG Subscriber Information to AAA and
RADIUS" on page 92.
[45] Acct-Authentic
Use the following command to manage the Acct-Authentic RADIUS attribute.
radius include acct-authentic
[49] Acct-Terminate-Cause
Use the following command to manage the Acct-Terminate-Cause RADIUS attribute.
radius include acct-terminate-cause
200
CLI Commands Used to Modify RADIUS Attributes
Use to set the Acct-Session-Id attribute format. Two formats are supported:
description Configures RADIUS client to use the generic format: erx
<interface identifier>:<hex number>. For example: erx atm
12/1:0.3:0000ef1
decimal Configures the RADIUS client to use a decimal format. For example:
435264
See radius acct-session-id-format
Example
host1(config)#radius acct-session-id-format decimal
Use the no version to negate the Acct-Session-Id format.
radius include acct-authentic
Use to include the Acct-Authentic attribute in Acct-On or Acct-Off messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include acct-authentic acct-on enable
Use the no version to restore the default, enable.
radius include acct-terminate-cause
Use to include the Acct-Terminate-Cause attribute in Acct-Off messages.