Configuring Cos And Applying Scheduler Maps (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 20: Configuring Schedulers (continued)
Task
Configure drop profile
map.
Specify the transmit rate.
Related
Documentation

Configuring CoS and Applying Scheduler Maps (NSM Procedure)

32
Action
1. Click the Add New icon.
2. Select drop-profile-map.
3. In the Loss Priority box, select the required loss priority—for example, high.
4. In the Protocol box, select the type of protocol—for example, any.
5. In the Drop Profile box, select the previously configured drop profile.
6. Click .
OK
1. Click the Add New icon.
2. Expand Transmit Rate.
3. Select Rate.
4. Under Rate, select the appropriate option:
To not specify transmit rate, select None.
To enforce a specific transmission rate, select rate and type the transmission rate that you
want to enforce.
To specify a percentage of transmission capacity, select percent and type an integer from 1
through 100.
To specify the remaining transmission capacity, select remainder.
5. Click OK.
Configuring CoS Classifiers (NSM Procedure) on page 15
Configuring CoS Code Point Aliases (NSM Procedure) on page 17
Configuring CoS Drop Profile (NSM Procedure) on page 19
Configuring CoS Forwarding Classes (NSM Procedure) on page 21
Configuring CoS Interfaces (NSM Procedure) on page 22
Configuring CoS Rewrite Rules (NSM Procedure) on page 28
Configuring CoS and Applying Scheduler Maps (NSM Procedure) on page 32
You associate the schedulers with forwarding classes by means of scheduler maps. You
can then associate each scheduler map with an interface, thereby configuring the queues
and packet schedulers that operate according to this mapping.
To configure CoS and apply scheduler maps:
In the navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure CoS and apply scheduler maps.
Copyright © 2010, Juniper Networks, Inc.