Syntax
FSM726# show snmp
Show Spanning Tree
The show spanning tree command displays the status and topology of the spanning-tree
configuration, as well as spanning-tree state of each port.
Brief
The
show spanning-tree brief
Syntax
FSM726# show spanning-tree brief
An example of the display output is shown below.
VLAN1
Spanning tree enabled protocol IEEE
ROOT ID Priority 32768
Address 0009.5b36.b007
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32768
Address: 0009.5b36.b007
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Port
Designated
Name Prio Cost Sts Cost Bridge ID
------- ---- ---- --- ---- --------------
Fa1/1 128 19 BLK 0
Fa1/2 128 19 BLK 0
Fa1/3 128 19 BLK 0
Fa1/4 128 19 BLK 0
...
Fa1/22 128 19 BLK 0
Fa1/23 128 19 FWD 0
Fa1/24 128 19 BLK 0
Gi1/25 128 4
BLK 0
Gi1/26 128 4
BLK 0
Command Line Interface
command gives a brief summary of the spanning-tree status.
0009.5b36.b007
0009.5b36.b007
0009.5b36.b007
0009.5b36.b007
0009.5b36.b007
0009.5b36.b007
0009.5b36.b007
0009.5b36.b007
0009.5b36.b007
700 Series Software Manual v2.1
6-9