Show Spanning-Tree - NETGEAR ProSafe GSM7228PS Cli Manual

no spanning-tree bpduforwarding
This command will cause the STP BPDU packets received from the network to be dropped if STP
is disabled.
Format
no spanning-tree bpduforwarding
Mode Global Config

show spanning-tree

This command displays spanning tree settings for the common and internal spanning tree. The
following details are displayed.
Format
show spanning-tree
Mode • Privileged EXEC
• User EXEC
Term Definition
Bridge Priority Specifies the bridge priority for the Common and Internal Spanning tree (CST). The
value lies between 0 and 61440. It is displayed in multiples of 4096.
Bridge Identifier The bridge identifier for the CST. It is made up using the bridge priority and the base
MAC address of the bridge.
Time Since Time in seconds.
Topology
Change
Topology Number of times changed.
Change Count
Topology Boolean value of the Topology Change parameter for the switch indicating if a topology
Change
change is in progress on any port assigned to the common and internal spanning tree.
Designated The bridge identifier of the root bridge. It is made up from the bridge priority and the base
Root
MAC address of the bridge.
Root Path Cost Value of the Root Path Cost parameter for the common and internal spanning tree.
Root Port Identifier of the port to access the Designated Root for the CST
Identifier
Root Port Max Derived value.
Age
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-22