Table of Contents
Advertisement
Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11.2.6.4
set sntp server
Use this command to add a server from which the SNTP client will retrieve the current time when
operating in unicast mode. Up to 10 servers can be set as SNTP servers.
set sntp server ip-address [precedence]
Syntax Description
ip-address
precedence
Command Defaults
If precedence is not specified, 1 will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the server at IP address 10.21.1.100 as an SNTP server
Matrix(rw)->set sntp server 10.21.1.100
11-126 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the SNTP server's IP address.
(Optional) Specifies this SNTP server's precedence in
relation to its peers. Valid values are 1 (highest) to 10
(lowest).
:
Hide quick links:
Advertisement
Chapters
Table of Contents
