Enterasys Matrix 2G4072-52 Configuration Manual page 1194

Routing Protocol Configuration Command Set
Configuring VRRP
13.2.6.2 create
Use this command to create a VRRP session. Each Matrix Series Platinum routing module or
standalone device supports up to 1024 VRRP sessions. Up to four VRIDs can be associated with an
individual routing interface.
create vlan vlan-id vrid
NOTE: This command must be executed to create an instance of VRRP on a routing
interface (VLAN) before any other VRRP settings can be configured.
Syntax Description
vlan vlan-id
vrid
Command Syntax of the "no" Form
The "no" form of this command disables the VRRP session:
no create vlan vlan-id vrid
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to create a VRRP session on VLAN 1 with a VRID of 1:
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#create vlan 1 1
13-92 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the number of the VLAN on which to create a
VRRP session. This VLAN must be configured for IP
routing as described in
Specifies a unique Virtual Router ID (VRID) to associate
with the routing interface. The value of vrid can range from
1 to 255.
Section 2.3.1.