Enterasys Matrix 2G4072-52 Configuration Manual page 1389

14.3.13.6 ip policy route-map
Use this command to assign a route map list to a routing interface.
ip policy route-map id-number
Syntax Description
id-number
Command Syntax of the "no" Form
The "no" form of un-assigns a route map list:
no ip policy route-map
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to assign route map 101 to VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip policy route-map 101
Specifies a route map ID number. Valid values are 100 -
199, and must match a value previously set using the
route-map command
NOTE: Only one route map list is allowed per
interface.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
Configuring Policy-Based Routing
(Section 14.3.13.2).
14-179