Enterasys Matrix 2G4072-52 Configuration Manual page 1291

Table 14-4 show macauthentication Output Details
Output
MAC
authentication
MAC user
password
Port username
significant bits
Port
Port State
Quiet Period
Reauth Period
Auth Allowed
Auth Allocated
Reauthentications Whether or not reauthentication is enabled or disabled on
Matrix DFE-Platinum and Diamond Series Configuration Guide
What It Displays...
Whether MAC authentication is globally enabled or
disabled. Set using the set macauthentication command as
described in Section
User password associated with MAC authentication on the
device. Set using the set macauthentication password
command as described in
Number of significant bits in the MAC addresses to be used
starting with the left-most bit of the vendor portion of the
MAC address. The significant portion of the MAC address is
sent as a user-name credential when the primary attempt to
authenticate the full MAC address fails. Any other failure to
authenticate the full address, (i.e., authentication server
timeout) causes the next attempt to start once again with a
full MAC authentication. Default is 48 and cannot be reset.
Port designation. For a detailed description of possible
port-string values, refer to
Whether or not MAC authentication is enabled or disabled
on this port.
Enables a reauthentication attempt for failed entries at the
period specified in seconds. Default value is 0 (never).
Reauthentication period for this port. Default value of 30 can
be changed using the set macauthentication reauthperiod
command described in
Number of concurrent authentications supported on this
port. Default is 1 and cannot be reset.
Maximum number of MAC authentications permitted on
this port. Default is 1 and cannot be reset.
this port. Set using the set macauthentication
reauthentication command described in
Security Configuration Command Set
Configuring MAC Authentication
14.3.7.3.
Section 14.3.7.4.
Section 4.1.1.
Section 14.3.7.16.
Section 14.3.7.13.
14-81