Enterasys Matrix 2G4072-52 Configuration Manual page 896

Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
11.2.5.7 traceroute
Use this command to display a hop-by-hop path through an IP network from the device to a
specific destination host. Three UDP or ICMP probes will be transmitted for each hop between the
source and the traceroute destination.
traceroute [-w waittime] [-f first-ttl] [-m max-ttl] [-p port] [-q nqueries] [-s
src-addr] [-r] [-d] [-t tos] [-F] [-g gateway] [-I] [-n] [-v] [-x] host [packetlen]
Syntax Description
-w waittime
-f first-ttl]
-m max-ttl
-p port
-q nqueries
-s src-addr
-r
-d
-t tos
-F
-g gateway
-I
-n
-v
11-106 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Specifies time in seconds to wait for a
response to a probe.
(Optional) Specifies the time to live (TTL) of the first
outgoing probe packet.
(Optional) Specifies the maximum time to live (TTL)
used in outgoing probe packets.
(Optional) Specifies the base UDP port number used in
probes.
(Optional) Specifies the number of probe inquiries.
(Optional?) Specifies the source IP address to use in
outgoing probe packets.
(Optional) Bypasses the normal host routing tables.
(Optional) Sets the debug socket option.
(Optional) Sets the type of service (TOS) to be used in
probe packets.
(Optional) Sets the 'don't fragment' bit.
(Optional) Specifies a loose source gateway (up to 8 can
be specified), or specifies a specific gateway, such as
gw1.
(Optional) Specifies the use of ICMP echo requests rather
than UDP datagrams.
(Optional) Displays hop addresses numerically.
(Supported in a future release.)
(Optional) Displays verbose output, including the size
and destination of each response.