Enterasys Matrix 2G4072-52 Configuration Manual page 969

Table 12-2 provides an explanation of the command output.
Table 12-2 show ip interface Output Details
Output
Vlan | Lpbk | Lo N Whether the interface is administratively and operationally
IP Address
Frame Type
MAC-Address
Incoming |
Outgoing Access
List
IP Helper Address Whether or not an IP address has been designated for
MTU
ARP Timeout
Proxy Arp
ICMP
Policy routing
Matrix DFE-Platinum and Diamond Series Configuration Guide
What It Displays...
up or down.
Interface's IP address and mask. Set using the ip address
command as described in
Encapsulation type used by this interface. Set using the arp
command as described in
MAC address mapped to this interface. Set using the ip
mac-address command as described in
Whether or not an access control list (ACL) has been
configured on this interface using the commands described
in Section 14.3.12.
forwarding UDP datagrams from this interface. Set using the
ip helper-address command as described in
Section 12.2.5.3
Interface's Maximum Transmission Unit size.
Duration for entries to stay in the ARP table before expiring.
Set using the arp timeout command as described in
Section 12.2.4.7.
Whether or not proxy ARP is enabled or disabled for this
interface. Set using the ip proxy arp command as described
in Section 12.2.4.5.
ICMP (ping) settings. By default, ICMP messaging is
enabled on a routing interface for both echo-reply and
mask-reply modes. If, for security reasons, ICMP has been
disabled, it can be re-enabled using the ip icmp command as
described in Section
Whether or not policy-based routing has been configured on
this interface as described in
IP Configuration Command Set
Configuring Routing Interface Settings
Section 12.2.1.5.
Section 12.2.4.2.
Section
12.2.6.9.
Section 14.3.13.
12.2.4.6.
12-9