Enterasys Matrix 2G4072-52 Configuration Manual page 1096

IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12.2.9.20 hardware-address
Use this command to specify parameters for a new DHCP client address. This command also
enables DHCP host configuration mode.
hardware-address hardware-address [type]
Syntax Description
hardware-address Specifies the MAC address of the client's hardware
type
Command Syntax of the "no" Form
The "no" form of this command removes the hardware address:
no hardware-address hardware-address [type]
Command Type
Router command.
Command Mode
Any DHCP configuration
Command Defaults
If type is not specified, Ethernet will be applied.
Example
This example shows how to specify 0001.f401.2710 as an Ethernet MAC address for the
"localpool" address pool:
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#hardware-address 0001.f401.2710 ethernet
12-136 Matrix DFE-Platinum and Diamond Series Configuration Guide
platform.
(Optional) Specifies a hardware protocol or client class
name. Valid values and their corresponding meanings are:
•
1 - 10Mb Ethernet
•
6 or ieee802 - IEEE 802 networks
•
client-class name - Client class (configured as described
in Section 12.2.9.21).
•
ethernet - 10Mb Ethernet
mode.