Enterasys Matrix 2G4072-52 Configuration Manual page 1008

IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12.2.6.11 traceroute
Use this command to display a hop-by-hop path through an IP network from the device to a
specific destination host. Three ICMP probes will be transmitted for each hop between the source
and the traceroute destination.
traceroute host
Syntax Description
host
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router1#
Command Defaults
None.
Examples
This example shows how to use traceroute to display a round trip path to host 192.167.252.46. In
this case, hop 1 is an unnamed router at 192.167.201.2, hop 2 is "rtr10" at 192.4.9.10, hop 3 is
"rtr43" at 192.167.208.43, and hop 4 is back to the host IP address. Round trip times for each of the
three ICMP probes are displayed before each hop. Probe time outs are indicated by an asterisk (*):
Matrix>Router1#traceroute 192.167.225.46
Traceroute to 192.167.225.46, 30 hops max, 40 byte packets
1 10.00 ms 20.00 ms
2 20.00 ms 20.00 ms
3 240.00 ms *
4 <1 ms *
TraceRoute Complete
12-48 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies a host to which the route of an IP packet will be
traced.
20.00 ms 192.167.201.2 [
20.00 ms 192.4.9.10 [enatel-rtr10.enatel.com
480.00 ms 192.167.208.43 [enatel-rtr43.enatel.com
20.00 ms 192.167.225.46 [enatel-rtr46.enatel.com
]
]
]
]