Enterasys Matrix 2G4072-52 Configuration Manual page 1128

Routing Protocol Configuration Command Set
Configuring RIP
13.2.2.19 passive-interface
Use this command to prevent RIP from transmitting update packets on an interface.
passive-interface vlan vlan-id
NOTE: This command does not prevent RIP from monitoring updates on the interface.
Syntax Description
vlan vlan-id
Command Syntax of the "no" Form
The "no" form of this command disables passive interface:
no passive-interface vlan vlan-id
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to set VLAN 2 as a passive interface. No RIP updates will be transmitted
on VLAN 2:
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#passive-interface vlan 2
13-26 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the number of the VLAN to make a passive
interface. This VLAN must be configured for IP routing as
described in Section 2.3.1.