Enterasys Matrix 2G4072-52 Configuration Manual page 1199

13.2.6.6 advertise-interval
Use this command to set the interval in seconds between VRRP advertisements. These are sent by
the master router to other routers participating in the VRRP master selection process, informing
them of its configured values. Once the master is selected, then advertisements are sent every
advertising interval to let other VRRP routers in this VLAN/VRID know the router is still acting as
master of the VLAN/VRID.
advertise-interval vlan vlan-id vrid interval
NOTE: All routers with the same VRID should be configured with the same
advertisement interval.
Syntax Description
vlan vlan-id
vrid
interval
Command Syntax of the "no" Form
The "no" form of this command clears the VRRP advertise interval value:
no advertise-interval vlan vlan-id vrid interval
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Specifies the number of the VLAN on which to configure
the VRRP advertisement interval. This VLAN must be
configured for IP routing as described in
Specifies a unique Virtual Router ID (VRID) associated
with the routing interface. Valid values are from 1 to 255.
Specifies a VRRP advertisement interval to associate with
the vrid. Valid values are from 1 to 255 seconds.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring VRRP
Section 2.3.2.
13-97