Routing Protocol Configuration Command Set
Configuring RIP
13.2.2.3
neighbor
Use this command to instruct the router to send unicast RIP information to an IP address. RIP is
normally a broadcast protocol. In order for RIP routing updates to reach nonbroadcast networks, the
neighbor's IP address must be configured to permit the exchange of routing information.
neighbor ip-address
Syntax Description
ip-address
Command Syntax of the "no" Form
The "no" form of this command disables point-to-point routing exchanges:
no neighbor ip-address
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to instruct the system to exchange routing information with neighbor
192.5.10.1:
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#neighbor 192.5.10.1
13-6 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the IP address of a directly connected neighbor
with which RIP will exchange routing information.